Product Overview
Tesla Model 3 Front Mud Guards – Easy Install, No-Drill
Sold as set of Left+Right
Custom 3D-printed mud guards designed specifically for the Tesla Model 3 front wheel arches. These splash guards provide extra protection against dirt and road debris while maintaining a clean, factory-like look.
✔ Quick installation – no drilling or permanent modifications required
✔ Designed to fit perfectly on the Tesla Model 3
✔ Durable 3D-printed construction with a smooth matte finish
Preparation
Open up the hole for the push-in clip if needed.
Hardware Required
6x M3 x 8 mm stainless steel screws (hex button head or socket head recommended)
6x M3 stainless steel nuts
⚠️ Screw length must be exactly 8 mm for proper fit.
Tools Needed
Allen key for the M3 screws
Flat screwdriver (for removing Tesla’s push-in rivet)
Installation Guide
Clean the wheel arch area thoroughly – make sure there is no dirt or grit.
Remove the OEM Tesla plastic push-in rivet with a flat screwdriver.
Assemble the mud guard and back plate using the screws and nuts, but keep them slightly loose for easier adjustment.
Slide the mud guard into position: the back plate should sit behind the metal lip.
Adjust the fit, then reinstall the Tesla rivet.
Fine-tune the alignment if needed and finally tighten all screws.
✅ Perfect for Tesla Model 3 owners looking for an easy, reversible upgrade to keep their car cleaner and better protected.
